20_installation & maintenance
CALIBRATION MODE (ONLY DIGITAL INVERTER MOTOR)
Your Samsung washing machine detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1.
Remove laundry or any contents in the machine.
2.
Press the
Delay End
and
Spin
buttons simultaneously, and then press the
Power
button. The Machine
turns on with “
Cb
”
3.
Press the
Start/Pause
button to activate “
Calibration Mode
”.
4.
The drum rotates for approximately 4 minutes.
5.
When “
Calibration Mode
” is fi nished, “
End
” appears on the display, and the machine automatically
turns off. The washing machine is now ready for use.
ADDING DETERGENT
1.
Open the detergent drawer and then add the powder
detergent into the detergent compartment.
2.
Add detergent evenly so that it doesn’t brim over the
edge of the drawer.
•
Use a reasonable amount of detergent.
If you use more detergent than the standard
quantity or the water temperature is too low and the
detergent does not dissolve in the water completely
causing it to remain on the laundry and in the hose and tub, it may cause damage such
as dirtying and discoloring the laundry.
•
If you use a powder detergent and it remains on the laundry, it may cause a bad odor.
Rinse the laundry suffi ciently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration.
Make sure to insert it into the detergent compartment.
If the water pressure is low, the detergent may remain in the detergent compartment.
installation & maintenance
CAUTION
W3050_F500S_WA11F5_DC68-03272L-05_EN.indd Sec5:20
W3050_F500S_WA11F5_DC68-03272L-05_EN.indd Sec5:20
2014-11-10 1:07:25
2014-11-10 1:07:25