10_setting up your washer
setting up your washer_11
wash buTTon
Press this button to perform a wash only or to adjust the washing time.
You can set the wash time from between 4 to 30 minutes.
spin buTTon
Press this button to perform a spin cycle only or to adjust the spin time.
You can set the spin time from between 0 to 9 minutes.
When only a spin is selected, the spin time will be different from the total
remaining time. This is because the total remaining time includes the actual
spin time and the times for water draining and stopping.
rinse buTTon
Press this button to perform a rinse only or to adjust the rinse count.
You can set the rinse count up to five times.
Tub check
funcTion
/
If the Tub Check indicator on the display blinks (it blinks for 3 minutes), run
the Tub Clean course.
The Tub Clean function removes dirt from the tub to keep the laundry clean.
chilD-lock
funcTion
/
This is a device to protect children from being accidentally hurt while playing
with the washer.
• How to start the Child-Lock function:
- Press the “Power” button to go to an initial washing mode.
- By pressing “
start/pause
” button, you start washing and in case Child Lock
function is needed during the laundry
- Press both the “Rinse” and “Spin” buttons at the same times.(for 3 seconds)
(Note: You cannot perform the function without the “Power” button on.)
• To release the function of Child-Lock: In case the “Child-Lock” is
programmed, press both the “Rinse” and “Spin” buttons at the same time.
remaining Time,
Delay sTarT
Time, error
Display
Displays the remaining wash time.
Displays the reserved delay start time.
Displays the error state if a problem occurs in the washing machine so that
you can take action.
soak buTTon
Press this button to perform a soak wash.
You can set the soak time from between 10 to 60 minutes.
Delay sTarT
buTTon
Press this button to finish the wash at a specified time.
Turn off your washing machine to cancel a reserved delay start.
You can set the delay start time from between 3 to 19 hours.
lasT seTTing
Press this button to load the settings for the last course.
Perform a wash course using the last used settings without having to enter
them manually again.
Your choices are automatically saved when you press the Start/Hold button.
To use a memorized course, press the Last Settings button and then press
the Start/Hold button.
- The memorized functions will be displayed on the panel.
The Delay start and Water level settings are not automatically saved
and will be reset after the wash.
eco Tub clean
Use this program to clean the tub, it will keep the tub clean and sanitary.
The TUB CHECK LED is turned on to notify the user that it is time to clean the tub.
The powerful spinning force of the washing tub pulsator removes the
contaminations from the exterior of the washing tub to prevent odors or secondary
contamination.
waTer leVel
buTTon
The water level is automatically adjusted. However, you can select the water
level manually by pressing this button.
waTer supply
buTTon (opTion)
Each press of the button cycles through the type of water,
Cold
Cold + Hot
Hot
Cold
15
01
SETTI
ng
U
p
y
OU
r
W
ASHE
r
10
11
12
13
9
8
14
CAUTION
6
7
5
4
WA10G9TEC-02961C-04_EN.indd 11
2012-11-13 �� 4:58:21
