TO WASH
1. Before starting to wash, proceed as follows,
Connect the water supply
hose and open the water tap.
• Lay the drain hose down toward
a sinkhole. (In case no drain pump)
• Place the drain hose in sink or bath.
(In case no drain pump)
• Connect the power cord to the power
supply outlet.
2. Set the WASH SELECTOR
KNOB to the desired mode.
3. Set the WTER SELECTOR
KNOB to the desired mode.
(FOR SW-T65B1, SWT65C1)
4. Set the CYCLE SELECTOR KNOB to
“WASH.RINSE”.(in case drain pump WASH)
5. Fill water in the wash tub
and add the detergent.
6. Load laundry in the
wash tub and fill water
to proper water level.
7. Set the WASH TIMER
1-15 minutes.
8. After washing, set the CYCLE
SELECTOR
KNOB to 'DRAIN' for drain.
TO SPIN DRY
1. Transfer the clothes into the
spin basket and arrange the
clothes evenly.
2. Be sure to replace the safety
cover and close the
inner lid.
3. Close the spin
dryer lid.
4. Set the SPIN DRY
TIMER 1-5minutes.
TO RINSING
1. Set the cycle selector KNOB to
‘WASH.RINSE’.
(In the case of
drain pump
‘WASH’)
2. Supply the proper amount of water
so as not to delete one space overflow
the top of the washing tub.
3. Set the WASH TIMER to
2~3 minutes.
4. Drain the water. Set the delete
one space cycle selector
KNOB to ‘DRAIN’.
5. Repeat this cycle until drain
water is clean. (2~3 cycles)
OVER FLOW RINSE
1. Keep supplying
water(adjust water
pressure to ensure
that the amount of
water supplied does not exceed the amount
of water drained.)
2. Set the WASH TIMER
6~8 minutes.
3. As soon as the
WASH TIMER
shuts off, turn off
the water tap.
4. Set the CYCLE
SELECTOR KNOB
to ‘DRAIN’.
WASHING PROCEDURE
Soft
Normal
WASH SELECTOR
WATER SELECTOR
Wash
Spin
Wash/Rinse
Drain Rinse
CYCLE SELECTOR
Wash
Drain
CYCLE SELECTOR
Wash/Rinse
Drain Rinse
CYCLE SELECTOR
Wash
Drain
CYCLE SELECTOR
Wash/Rinse
Drain Rinse
CYCLE SELECTOR
Wash
Drain
CYCLE SELECTOR
0
3
1
4
2
5
SPIN DRY TIMER
0
9
3
12
6
15
WASH TIMER
0
9
3
12
6
15
WASH TIMER
0
9
3
12
6
15
WASH TIMER
0
9
3
12
6
15
WASH TIMER
inner lid
safty cover
3
