16
Technical Specifications
17
ENGLISH
SAMSUNG continually strives to improve its products. Both the design specifications
and these user instructions are thus subject to change without notice.
DISC
GENERAL
RELIABILITY
DRIVE
PERFORMANCE
FRONT PANEL
REAR PANEL
OPERATING
ENVIRONMENT
Disc types supported
in write mode
Erasing disc types
Disc diameter
Disc types supported
in read mode
Data transfer rate
Access time (typical)
Recording
Reading
CD-R : 600 KB/sec. (4X), 1,200 KB/sec. (8X),
1800 KB/sec. (12X), 2,400 KB/sec. (16X),
3600 KB/sec. (24X), 4,800 KB/sec. (32X),
CD-R W : 1500 KB/sec. (10X), 600 KB/sec. (4X),
CD: CAV 40 Access Time CD-RW : CAV 32 Access Time
PIO Mode 4:16.6MB/sec,
Multiword DMA mode 2:16.6MB/sec
110ms (typical)
Data Buffer
8MB
Laser
Semiconductor laser
Slide mechanism
Stepping motor
Spindle motor
Brushless motor
Load mechanism
ERROR RATE
Eject button
Indicator
Headphone output
Volume control
Required power
Interface connector
Audio output
Jumper block
Tray. DC motor (Soft Eject).
Mode 1: 1 block/10
12
, Mode 2: 1 block/10
9
Auto eject or Auto inject
Play / Read (GREEN) Record (RED), Operation LED
Stereo mini-jack (Ø 3.6 mm) 0.65±20% (vrms) 33
Ω
Dial type
+5 VDC: 1.5 A (max.), +12 VDC: 1.5 A (max.)
ATAPI (E-IDE)
Line out 0.75±20% (vrms) : 47K
Ω
Device configuration jumper
Operations
Temperature: 5~45°C Humidity: 10~80%
Storage
Temperature: -25~55°C Humidity: 10~90%
Dimensions
Net weight
MTBF
CD-DA, CD-ROM mode 1, CD-ROM XA mode 2, Form 1,
Form 2, CD-Plus, CD-Extra, Photo-CD (Single, Multi-session),
Video CD ready, Enhanced CD, CD-I/Fmv, CD-R, CD-RW,
CD-TEXT
CD-R, CD-RW
CD-RW
120 mm or 80 mm
148.2 (W) x 42 (H) x 184 (D) mm (including bezel)
765 g
125,000 POH(Duty 20%)
ITEM
SW-232
Problem
When the MPEG software
plays a Video CD, the
pictures are not regular and
the running speed is too slow.
Adjust the size of the replay screen.
The Disc is not in message is
displayed even though a disc
has been inserted.
The computer may not recognize the disc if you
start playback too quickly after inserting the disc.
Open and close the disc compartment and try again.
The CD-R/RW drive is not
detected after it is connected
to a sound card.
The interface mode of the sound card is AT-BUS.
You must therefore connect the CD-R/RW drive to
the IDE port on the PC mother board, rather than
to the sound card, or install an E-IDE compatible
sound card.
Clean the disc and try again.
After checking the display resolution, adjust it,
if necessary.
Meaning / Solution
IN CD has the Formatted
Disc Eject function.
Right-click the mouse on TRAY ICON (right side of
the menu bar at the bottom of the monitor) and then
select "Eject" to take the CD out.
Select the drive where the disc is inserted from
Windows Explorer.
Right-click the mouse and select "Eject" to take
the CD out.
When recording NERO,
it will be recorded not on a
CD but a form of image file.
This seems to occur when you select the recording
function as the system selects "Image Recorder"
instead of SW-232.
In this case, select a recorder from the menu items
at the upper part of NERO and then select SW-232
from the Recorder Selection window.
The Recorder cannot
recognize the disc.
Use the firmware automatic upgrade function
available at the ODD service website to download
the newest firmware and then reinstall the recording
software which is included in the bundle.
- www.samsungodd.com
- www.samsungelectronics.com
When installing the recording software, try not to
install the software before the ROM drive as this
makes the Image Recorder selected.
