5.2 Installing a Hard Disk Drive (HDD)
1. Hold the HDD by the sides with the 4 screw studs facing up.
2. Attach the ribbon cable between the HDD and the Voice Mail card. The 4 spare pins on one end of
the connector are not used.
3. Position the Voice Mail card with solder side up, so that the holes in the card line up with the studs
on the HDD adapter.
4. Insert the 4 screws, and tighten until snug. DO NOT OVERTIGHTEN.
5. Replace the SVMi-20E in the phone system.
6. Inserting or Removing a Compact Flash Adapter
6.1 Removing the Compact Flash (CF) Adapter
1. Do a proper shut down of the SVMi-20E. (Steps for performing a proper shut down are described in
the section Correct System Shutdown.)
2. Power down the phone system and remove the SVMi-20E card.
3. Hold the unit with the CF Adapter supported in your hand, held by the edges.The solder side of the
card should be facing up.
4. Remove the 4 retaining screws so that the CF Adapter becomes detached.
5. Still holding the CF Adapter by the edges invert the card (component side up) and gently unplug
the ribbon cable.
6. Gently pack the CF Adapter in the SEC provided packaging.
6.2 Installing the Compact Flash (CF) Adapter
1. Hold the CF Adapter by the sides with the 4 screw studs facing up.
2. Attach the ribbon cable between the CF Adapter and the Voice Mail card. The 4 spare pins on one
end of the connector are not used.
3. Position the Voice Mail card with solder side up, so that the holes in the card line up with the studs
on the CF adapter.
4. Insert the 4 screws, and tighten until snug. DO NOT OVERTIGHTEN.
5. Replace the SVMi-20E in the phone system.
SVMi-20E Installation / May 2009
5
Home Page
