Samsung SRP-350 Bixolon, Руководство оператора

Страница: 23 / 31

0 ≤ y ≤ 255
[Description] Sets the horizontal and vertical motion units to approximately 25.4/x mm {
1/x inch and } and approximately 25.4/y mm {1/y inches}, respectively.
When x and y are set to 0, the default setting of each value is used
•
GS V m ,
•
GS V m n
[Name] Select cut mode and cut paper.
[Format]
•
ASCII GS V m
Hex 1D 56 m
Decimal 29 86 m
•
ASCII GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range]
•
m = 1, 49
•
m = 66, 0 ≤ n ≤ 255
[Description] Selects a mode for cutting paper and executes paper cutting.
The value of m selects the mode as follows:
M Print mode
0, 1, 49 Partial cut (one point left uncut)
66 Feeds paper (cutting po [n × (vertical motion unit)]), and
cuts the paper partially (one point left uncut).
GS W nL nH
[Name]
Set printing area width.
[Format] ASCII GS W nL nH
Hex 1D 57 nL nH
Decimal 29 87 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the printing area width to the area specified by nL and nH.
The printing area width is set to [(nL + nH × 256) x horizontal motion
unit)] inches.
Printable area
Left margin Printing area width
GS \ nL nH
[Name]
Set relative vertical print position in page mode
[Format] ASCII GS \ nL nH
Hex 1D 5C nL nH
Decimal 29 92 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the relative vertical print starting position from the current position in
page
mode.
This command sets the distance from the current position to [(nL + nH
x
256) x vertical or horizontal motion unit] inches.