SAMSUNG Proprietary-Contents may change without notice
Test Procedure
6-8
This Document can not be used without Samsung's authorization
- PCS Test items
TEST ITEMS
PROCEDURE
1. PREPARANCE
Set test equipments up.
[ 4 7 * 8 6 9 # 1 2 3 5 ] : Enter the Test Mode
"0 0 1" : Suspend
Confirm that the phone is in the "PCS Mode".
(If not PCS Mode, Use Test Command "022""3XXXX" and Push
the [OK] Key, and enter "0 0 2" to restart)
If you select a wrong key, press " # ", then enter new command.
To exit the Test Mode at any time, just press [0 0 2].
2. FREQUENCY
ACCURACY
"0 0 1" : Suspend.
"0 1 3 0 6 0 0 * " : Set channel to 600.
"0 1 1" : Carrier On.
"0 1 9 X X X ' END[Push and Hold] ' " : Set AGC Code(XXX) level.
Measure the TX frequency : 1880.00MHz±300Hz.
3. OCCUPIED CDMA
BANDWIDTH
"0 0 1" : Suspend.
"0 1 3 0 6 0 0 * " : Set channel to 600.
"0 1 1" : Carrier On.
"0 1 4" : Spread spectrum.
"0 1 9 X X X ' END[Push and Hold] ' " : Enter AGC Code(XXX) to adjust
RF Output Power.
Measure the bandwidth (spec: 1.23MHz).
4. LIMITATIONS ON
EMISSIONS
"0 0 1" : Suspend.
"0 1 3 0 6 0 0 * " : Set channel to 600.
"0 1 1" : Carrier On.
"0 1 4" : Spread spectrum.
"0 1 0 Select 1 *" :Set PA_R1 to High Gain Mode
"0 1 9 X X X ' END[Push and Hold] ' " : Enter AGC Code(XXX) to adjust
RF Output Power.
Measure the spurious at F
C
±1.25MHz
spec: F
C
±1.25MHz below 42dBc/30kHz
5. GATED POWER &
TIME
Set the service option 2.
Set the data rate Eighth (1200bps).
Registering: HHP
→
HP8924C.
Call
: HP8924C
→
HHP.
Measure the Gated Power & Time.
spec : Gated Power - at least 20dB
Gated Time - Rising Time : below 6
㎲
Falling Time : below 6
㎲
Burst Time : below 1.247
㎳