
12
11
Battery Life
The battery life has a 6 months warranty after purchase.
As time goes by, there will be a reduction in the battery s
power. When battery s power capacity is reduced by
half, purchase a new battery and replace it.
How to use the battery?
Charge the battery for approximately 24
hours before using.
Always remove the battery from the remote
set, when you are not using the remote set
for an extended period.
Charge the battery until you see .
Phone Installation (Continue)
Open the battery
cover.
1
Place the battery as
shown in the picture.
2
Loading the battery to the remote set
Rearrange the line
by setting the
battery as shown in
the picture.
3
Close the
battery cover.
4
To turn on the power : Press and hold the button for more than 2
seconds until you begin to hear the beeping sound.
If it does not turn on when you press the button, then you probably
need to recharge the remote set. It should then turn on automatically.
Please recharge the battery for 24 hours before using it.
If you do not charge the battery for at least 6 hours, then in other protect it,
the battery must be fully charged or it will stop operating.
To turn off power : Press and hold the button for more than 3 seconds
until you hear the beeping sound.
If you hear a error sound when you turn on the power, register the remote
set.(Refer to page 39)
To turn on / off the power
Preparation &
Installation
SP-C501R(¿ „fi) 2004.2.25 9:11 AM ˘
` 11 TWIN1 HyperLaserG3
Содержание SP-C501RSL
Страница 1: ......
Страница 25: ...Memo fi 2004 2 25 9 12 AM 47 TWIN1 HyperLaserG3 ...