13
Video Netcam |
SNC-L200
12
Video Netcam |
SNC-L200
Connecting
Connecting
2.2.2. To install as a tabletop type
1. Remove the cover from the back of the SET. Plug in LAN-CABLE and POWER
CORD. Align the two to the groove of the cover, and then close THE cover as
shown in the figure below.
2. Suspend the LAN-CABLE and POWER CORD to the groove of “A” portion. Let the
SET stand.
2.2.3. To install in other locations
Remove the cover from the back of the SET. Plug in LAN-CABLE and POWER
CORD. Align the two to the groove of the cover, and then close the cover. Follow the
other installation methods to secure the CABLE.
* When using after securing the SET on a separate stand, make sure the stand can
be secured to the nuts on the back of the SET.
2.3 PIR Sensor and Flash Movement
FLASH
PIR SENSOR
(Illumination range)
Detection ranges of PIR SENSOR are as follows:
Horizontal range: Approximately 40 degrees
Vertical range: Approximately 85 degrees
Detection distance: 5m(Max)
* When the movement is fast, the horizontal detection distance may vary.
* Please avoid installing the set in a place under the direct sunlight, a place expected
considerable temperature change such as near to heater / air conditioning unit, a place
produces high humidity / oil / smoke or stains such as in a cooking room, and a place
having obstructions such as mirrors / glass that might cause erroneous sensor operation.
When PIR SENSOR moves, the illumination ranges of the FLASH LENS are as follows:
Horizontal range: Approximately 67 degrees
Vertical range: Approximately 67 degrees
Illumination distance: 5m(Max)
When installing the set, consider operation / detection range of the PIR Sensor.
When the PIR Sensor works the flash may function.
(Horizontal detection angle range)
(Vertical detection angle range)
