SAMSUNG Proprietary-Contents may change without notice
7. Disassembly and Assembly Instructions
7-
1
This Document can not be used without Samsung's authorization
7-1. Assembly
1
4
3
2
1) Attach conduction tape.[Figure 1]
2) Insert the SLIDE FPCB and CAMERA FPCB
[Figure 2]
※
Caution
1) Be careful of the possible damage on FPCB
2) Connector should be certainly clicked along
솓
marked line.
1) Combine NAVI KEY PAD.[Figure 1]
2) Combine LCD/CAMERA MODULE and fixing soldering
area.[Figure 2]
※
Caution
1) Be careful of the possible damage on FPCB
1) After adjust FPCB on the LCD, Attach conduction
tape.[Figure 1]
2) After combine Lower, screw the 4 Bolts.[Figure 2]
1) As seen figure 1, combine the Screw Cap.[Figure 1]
2) combine the 3*4 KEY PAD on the front.[Figure 2]
< Figure 1 >
< Figure 2 >
conduction
TAPE
SLIDE FPCB
CAMERA
FPCB
LCD Module
< Figure 1 >
< Figure 2 >
CAMERA
MODULE
soldering area
NAVI KEY
PAD
< Figure 2 >
< Figure 1 >
conduction tape
Screw(L3.0)
Torque:1.1~1.3Kgf
ㆍ
Cm
< Figure 2 >
< Figure 1 >
Screw Cap
3*4 KEY PAD