Exploded and assembling View
This Document can not be used without Samsung's authorization
SAMSUNG Proprietary-Contents may change Without notice
8-3
1) When you soldering, be careful about damage of component.
2) Bond the soldered part to prevent crack.
1) Insert depending on SPEAKER's color.
2)
Bond the soldered part to prevent crack.
1)
Combine carefully, because CONNECTOR can break easily.
1)
Combine carefully, because CONNECTOR can be broken easily.
1)
Be careful about damage of
RECEIVER WIRE and Irda Light.
SPEAKER WIRE
B'D 안쪽으로
GND가 보이도
록 정리할것
2
3
4
5
6
1) Solder RECEIVER according to polarity.
1) Solder the SPEAKER WIRE in polarity with picture.
1) Remove the white paper on the back of SUB B'D .
2) Insert the LCD FPCB to the CONNECTOR .
3) Check SILK line.
1)
Combine LCD and PBA ASS'Y homogizing 3points hole.
2) Attach insulation TAPE on connector with tweezers.
3) Attach white two faces TAPE
1) Attach
SPEAKER according to SUB BOARD's base line after
remove SPEAKER white paper.
2)
SPEAKER WIRE avoids that blight.
3) Arrange
SPEAKER WIRE inside SUB B'D so that GND(gold color)is
seen.
1
) Put the NAVI' KEY on the SLIDE UPPER.
2) First, Put the top portion department of LCD module on
the UPPER, the last lower column department .
극성확인 할 것
1
붉은선 좌측, 파란선 우측
Check Polarity
Left side: Red Wire , Right side: Blue Wire
A
rranges
SPEAKER
WIRE inside SUB
B'D so that
GND(gold
color)is seen.
8-2. Assembly