English
13
ENG
Connection & Control
S
TO CONTROL THE CAMERA USING RS-485 DEVICE
VIA COAXIAL COMMUNICATIONS
Connect the product to DC 12V power source or insert 4 AA-sized
batteries into the battery compartment.
Set the protocol switch 7 to
ON
.
Connect the
VIDEO IN
of the unit and
VIDEO OUT
of the AI Camera
directly.
For proper data communication, the unit and AI camera should be connected directly.
(If you connect a DVR or keyboard in the middle of the main unit and AI camera,
bidirectional communication will not be established.)
Connect
VIDEO OUT
of the main unit to a monitor’s video input terminal.
Connect
TX(+/-)
of RS-485 device to
RX(+/-)
of the main unit.
(For a full duplex system, connect
RX(+/-)
of RS-485 device to
TX (+/-)
of
main unit additionally.)
Using RS-485 device, you can control the camera menu.
For proper coaxial communication, AI camera should be set to Samsung protocol.
Refer to the switch settings. (See page 17)
1.
2.
3.
–
4.
5.
6.
–
ADDRESS
(X)100
(X)10
(X)1
POWER
OFF
ON
CABLE
COMPENSATION
S
L
REMOTE CONTROLLER SCX-RD100
POWER
STATUS
TERMINATION
PROTOCOL
1
ON
2345678
1
ON
2
By factory default, protocols of SAMSUNG and PANASONIC are supported.
For additional protocols, update the following software program via the web.
Input of video signal is required to control RS-485.
NOTE
