28_
operating
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it firmly straight
back.
• If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
• The inside of the ice bucket is very cold
when the refrigerator is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with the
refrigerator.
The water supply to this refrigerator must
only be installed/connected by a suitably
qualified person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
CAUTION
GOING ON VACATION...
If you are going on a long vacation or business trip
and won’t use the water or ice dispensers for a
long time:
- Close the water valve. Otherwise, water leakage
may occur.
- Remove all food.
- Unplug the refrigerator.
- Wipe excess moisture from inside and leave
the doors open. Otherwise, odor and mold may
develop.
ICE MAKER DO’S AND DON’TS
Do not put your fingers, hands or any other
unsuitable objects in the chute or ice-maker
bucket.
- You can hurt yourself or damage the refrigerator.
Never put your finger or any other objects in the
dispenser opening.
- You can injure yourself.
Do not try to disassemble the ice maker.
Do not wash or spray the ice bucket with water
while it is in the refrigerator.
Remove it to clean it.
• When you insert the Ice maker tray, be
sure that the tray is well centered at the
entrance.
Otherwise, the tray may be stuck.
Water clouding phenomenon
• All water provided to the refrigerator
flows through a core alkaline water filter.
In the filtering process, the pressure
of the water that has flowed out of the
filter has increased, and the water has
become saturated with oxygen and
nitrogen. When this water flows out into
the air, the pressure plummets and the
oxygen and nitrogen get supersaturated,
which results in gas bubbles. The water
may temporarily look misty or cloudy due
to these oxygen bubbles. After a few
seconds, the water will look clear.
CAUTION
DA68-02836K (EN)-08.indd 28
2015. 8. 26. �� 11:37
