Setting Up
_9
sEtting uP tHE REFRigERAtoR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of
the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled
and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food
and drinks in the Refrigerator after the temperature is sufficiently cool.
REMoVing tHE REFRigERAtoR DooRs
If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.
Disassemble the Refrigerator doors
1. With the door opened, remove the Top Table cap
(
1
) with a Flat head screwdriver, and close the
door.
Remove the 3 screws holding down the Top Table
and remove the Top Table(
2
).
tools you will need
2
1
Philips screwdriver
10mm Socket Wrench
Allen wrench(3/16”)
Flat-blade screwdriver
Pliers
Check the accessory list below.
01
s
E
tting
u
P
Water filter
(DA29-00002B)
Hex wrench
(DA80-00002C)
Fastener
(DA60-00143B)
Compressin fitting
(DA62-00305A)
Compression nut
(DA74-00070B)
Clip fitting lock(red)
(DA61-04522A)
DA68-01819A.indb 9
2009.9.22 3:9:28 PM
