Samsung RF263AE, Руководство пользователя

Страница: 9 / 76

Setting Up
_9
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and
functions of the appliance.
By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions in
this manual.
2. Once the Refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer will
get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator once
the temperature is sufficiently cool.
01
setting
u
P
REMOvING THE REFRIGERATOR DOORS
If your entrance won’t allow the Refrigerator to pass easily
through it, you can remove the doors.
Disassemble the Refrigerator doors
1. With the door closed, remove the top table(
1
)
using a Philips screwdriver, and then disconnect the
wires(
2
). Remove hinge screws(
3
) and ground
screw(
4
)
2
1
3
4
2. Lift the door straight up to remove.
3. With a Philips head screwdriver, remove the two
screws(
10
) attached to the lower left and right
door hinges.
With an Allen Wrench(5mm), remove the two hex
head bolts(
11
) attached to the lower left and right
door hinges.
Remove the lower left and right door hinges(
12
).
Tools you will need
10
12
11
Philips screwdriver 10mm Socket Wrench Allen wrench(5mm)
Flat-blade screwdriver Pliers
Check the accessory list below.
Water filter
(DA29-00003B)
Hex wrench
(DA80-00002C)
Compression
fitting
(DA62-00305A)
Compression
nut
(DA74-00070B)
Fastener
(DA60-00143B)
Washer
(DA80-00002C)
DA68-01812H.indb 9 2009.8.10 9:4:5 AM