English
23
02
OPERA
TING
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
If you use all the ice at once, you must
repeat ice making Steps 2 and 3, left.
However, only wait 8 hours before dispensing the
first 4 to 6 ice cubes. This will replenish the ice
cubes and ensure maximum ice production.
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it firmly
straight back.
If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and
try again.
• The inside of the ice bucket is very cold
when the refrigerator is operating.
Do not reach deep inside the ice
bucket.
• Use only the ice maker provided with
the refrigerator. The water supply to this
refrigerator must only be installed/connected
by a suitably qualified person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
CAUTION
Going on vacation...
If you have a long vacation or business trip and
won’t use the water or ice dispensers for a long
time:
- Close the water valve. Otherwise, water
leakage may occur.
- Remove all food and ice in the ice bucket.
- Unplug the refrigerator.
- Wipe excess moisture from inside and leave
the doors open. Otherwise, odor and mold
may develop.
Ice Maker Do’s and Don’ts
• Do not put your fingers, hands or any other
unsuitable objects in the chute or ice-maker
bucket
- It may result in personal injury or material
damage.
• Never put your finger or any other objects in
the dispenser opening.
- It may cause injury.
• Do not try to disassemble the ice maker.
• Do not wash or spray the ice bucket with
water while it is in the refrigerator. Remove it
to clean it
When you insert the Ice maker tray, be
sure that the tray is well centered at the
entrance.
Otherwise, the tray may get stuck.
Water clouding phenomenon
All water provided to the refrigerator flows
through the core filter which is an alkaline
water filter. In the filtering process, the
pressure of the water that has flowed out
of the filter is increased, and the water
becomes saturated with oxygen and
nitrogen. When this water flows out into
the air, the pressure plummets and the
oxygen and nitrogen get supersaturated,
which results in gas bubbles. The water
may temporarily look misty or cloudy due
to these oxygen bubbles. After a few
seconds, the water will look clear.
CAUTION
RF22KR_DA68-02897B-00_EN.indd 23
2015-12-21 7:50:51
