EN:
Exterior
- Wipe with a damp sudsy cloth, then dry.
- For stubborn strains and for periodic waxing, use silicon wax.
Interior
- Wash entire compartments with a baking soda solution (two table-
spoon of baking soda to one quart of warm water). Rinse and dry.
Interior parts
- Wash compartment shelves, door shelves etc.
With either the baking soda solution or a mild detergent and warm
water. Rinse and dry.
Magnetic door gaskets
-Wash with warm sudsy water,rinse throughly and dry.
The drip water tray
- To take out the drip water tray slide it out at a downward slant
Clean it once in a month.
- It it is not inserted properly, water will not evaporate or it will cause
unusual vibrating noises.
The finishing touch
-Insert all parts to proper location and set "Temperature control"
to desired setting.
HOW TO CLEAN THE UNIT
10
5
INITIAL USING METHOD
EN:
1. Place all shelves, all kinds of vessels in their proper positions
which have been removed for transportation.
2. Clean refrigerator and parts to remove dust incurred during
shipping
3. Set cold control knob at "COLD" position and let refrigerator oper-
ate for one hour. Freezer compartment should get slightly chilled
and motor should run smoothly with no noise but soft hum.
4. Store food after the temperature in the refrigerator gets suffi-
ciently low. It takes a few hours after starting the refrigerator to
reach the proper temperature.
5. Your refrigerator is operated by a compressor which switchs "on
and off" to maintain the intemal temperature. When the compre-
ssor is new it requires running in for a period of up to 2 months.
During this period it may operate a little noiser than normal. This
is quite normal and does not represent a fault.
EN: FOLLOW THE STEPS BEFORE TO BEGIN OPERATION OF YOUR REFRIGERATOR.
The cooling effects originates from refrigerant that is filled through
special process. Please ensure the pipes in the rear are intact.
Alert
This appliance adopts R600a refrigerant which is combustible.
During transportation and installation, please handle the appliance carefully
to protect the cooling system from damage.
- To avoid the combustible gas composed of the refrigerant leaked from the cooling circuit and the air,
please select the room size to accommodate t he appliance according to the refrigerant quantity.
The room size shall be calculated as per the criterion of 8g R600a per square metres.
For details of the refrigerant quantity, please refer to the manual.
- Do not start the appliance that has any damage. If any problems, please contact the dealer or
service centre.
The refrigarant leaked from the pipe may catch fire or hurt your eyes. If refrigerant leakage occurs,
please keep away the fire or potential fire source, and keep the room aired for several minutes.