Operation Instruction & Installation
Samsung Electronics
11-5
1
Remove the screws from the back of the PDP.
2
Use the screw and assemble the plastic hanger.
(Please refer to the following picture.)
1 Please ask the installers to install the wall
mount bracket.
2 Please be sure to check if the plastic hanger is
completely secured on both the left and right
side after hanging the SET on the wall mount
bracket.
3 Please avoid catching your fingers while
installing and adjusting the angle.
4 Please tightly secure the wall mount bracket to
the wall to avoid injury from a falling SET.
3
Tighten the screws of the plastic hanger (shown
in picture 2) to the back side of the PDP.
4
Remove the Safety Pins. Fasten the 4 plastic
latches assembled at step ( ) on the back side of
the PDP using the guide holes of the wall mount,
push ( ) and hook ( ) down to secure the PDP on
the wall mount as illustrated. Secure the PDP by
inserting the Safety Pins, not to fall from the wall
mount.
PDP panel
Wall attachment
panel bracket
Wall
11-2-4 Instructions on Securing the SET to the Wall Mount Bracket
Содержание PS42E7SX
