Samsung POWERbot SR10M70 Series, Руководство пользователя

Страница: 34 / 40

ENGLISH- 34
Troubleshooting
Symptom Checklist
The POWERbot is not
working at all.
f
Check if the emergency switch is on.
f
Check if all the icons are displayed on the display panel.
f Check if the POWERbot's battery is depleted.
– When "Lo" is displayed, place the POWERbot on the docking
station to charge it.
– When the battery indicator blinks, manually place the POWERbot
on the docking station to charge. (Only SR10M701
✴✴✴
series)
f
Replace the batteries (AAA type) if the remote control is not
working.
The POWERbot has stopped
during cleaning.
f When "Lo" is displayed on the display panel, place the POWERbot
on the docking station to charge it.
f
When the battery indicator blinks, manually place the POWERbot
on the docking station to charge. (Only SR10M701
✴✴✴
series)
f
When POWERbot is immobilized by an obstacle such as a cord,
threshold etc, pick it up and move it away from the obstacle.
– If any fabric or string is caught in a drive wheel, turn off the
emergency switch and remove the fabric or string before using
it again.
Suction power is weak.
f If the "Filter inspection indicator" is on, turn off the emergency
switch and clean the dustbin.
f
When there's too much dust in the dustbin, suction power may get
weakened. Turn off the emergency switch and empty the dustbin.
f
If the intake (on bottom of POWERbot) is blocked by foreign
matter, turn off the emergency switch and remove foreign matter
from the intake.
f When noise suddenly increase, turn off the emergency switch and
empty the dustbin.
The POWERbot cannot find
the docking station.
f
Check if there's a power failure or whether the power plug is
unplugged.
f Remove any obstacles around the docking station that may
prevent POWERbot from returning to the docking station.
f
When there's foreign matter on the charge pins, charging can be
affected. Clean the foreign matter off the pins.
The POWERbot suddenly
cleans diagonally.
f
Check if the docking station is installed along the grain of wooden
floors or tiles.
f
The POWERbot may clean in a diagonal direction if it is moving
to another area using the shortest route. It may also move at a
diagonal if it made contact with an obstacles at that angle, if it
was charged at the docking station at an angle, or if the grain of
the wooden/tile floor skewed is in that direction.
Point cleaning is not working.
f
If you point the red light directly at POWERbot, it may not move in
desired direction.
– Point the red light on the floor within 0.5 m of POWERbot.
✻ ✻
Do not use point cleaning in direct sunlight, under bright light, or
on dark floors.
VR7000_EN_DJ68-00763D-01_SA.indd 34 2017-02-03 오후 5:48:44