12
AA
Drainpipe and drain hose installation
You should test the drainage after completing the installation.
Prepare a little water about 2.0 liters.
1 Turn the cover drain pump, then pull it out.
2 Pour water into the indoor unit as shown in figure.
3 Confirm that the water flows out through the drain hose.
4 Reassemble the cover drain pump.
Testing the drainage
t *GZPVEPOPUQPVSXBUFSJOTJEFUIFXBUFSTVQQMZJOUBLFXBUFSNBZ
spill from the indoor unit.
t :PVDBODIFDLUIFESBJOBHFPOMZXIFOUIFBJSDPOEJUJPOFSJTJODPPM
mode.
Water leakage
check part
Hose
t *GBDPODFOUSBUFEESBJOQJQFJTJOTUBMMFESFGFSUPUIFöHVSFCFMPX
Concentrated drain pipe
JODI NN
or mor
e
1/100 or
mor
e slope
"JSWFOUJMBUJPO
Installing DPM
▶
8IFOJOTUBMMJOH%1.ZPVTIPVMETFUA%1.TFUUJOHUPUIFPVUEPPSVOJU
▶
If DPM model is not set, communication error may occur.
▶
While the outdoor unit is tracking the indoor unit for one minute after the power supply is turned on, the operation may
stop if the remote control reception signal of the installed indoor unit is different.
If using a multi system, refer to the manual supplied with the outdoor unit.
Installing MULTI
Содержание PC4SUSMB
Страница 1: ......
Страница 30: ...DB68 03760 05...