Samsung NX300, Руководство по обслуживанию

Страница: 7 / 102

Precautions
1-4
Copyrightⓒ since 1995 Samsung Electronics. All rights reserved.
1-3 Precaution for disassembly and reassembly
Component Precautions
FPCB
FPCB is brittle material. It can be easily damaged thus it should be handled with care.
It is recommended to use wooden or plastic tweezers for manual placement.
CCD (CMOS)
IR CUT Filter
LCD, LENS
Be careful not to stained your finger. It is recommended to use wooden or plastic tweezers
for manual placement. Stain is often caused by the Alcohol used in these components.
Find a clean, well-ventilated place to do your work.
PCB Use an anti-static mat as well as an anti-static wrist strap to avoid ESD damage to PCB.
CONNECTOR
The use wooden or plastic tweezers is recommended for manual placement.
Metal tip tweezer might make marks or damage.
BARREL Always follow proper direction while assembling the components of the barrel.
<Table 1-3>
1. Use the anti-static handing procedures included with the anti-static mat to ensure that there is no electrostatic
discharge and component damage.
2. Static electricity is the biggest danger to the PCB parts you are about to disassemble or assemble. It’s important
to use your anti-static wrist strap to prevent damage to these components.
3. Dismantling a discrete electronic component such as main capacitor is dangerous.
The capacitor contains high voltage, which can cause a severe electric shock if you touch it. This holds a
charge even when the unit is not plugged in and is capable of delivering a fatal shock.
4. Using excessive force during disassembly and assembly can damage locking parts. Use care when handling
“Locking parts” to avoid damage to FPCB or wire. Apply pressure only at the points designated in the maintenance
instructions.
5. Due to increasing environmental concerns, a number of restrictions have been placed on the material content
of electronic components and electronic assemblies. It requires utilizing Lead-Free (Pb-free) Soldering.
6. The following precautions must be observed when handling such components below.
CAUTION
!