Samsung NX10, Руководство по обслуживанию

Страница: 42 / 73

SAMSUNG This Document can not be used without Samsung’s authorization 5-5
Adjustment
7. If you press the Start button on the Shutter Speed adjustment tool, it will be start PTP communications and then
do the shooting as a 1/2000 shutter speed. Finally, shutter speed measured on the tools.
8. Adjustment tools→Transfer the measured value(Shutter Speed) to PC→Transfer to camera.
9. The adjustment value set after calculation it based on the 1/2000sec(0.488ms) of Offset value. After applying to
Offset value that means it will be start from 1/4000 sec, then the tools received the result value.
Compare to standard value as a 1/4000 sec (0.269ms), it decide the range of standard.
10. After finishing the adjustment, the result value will be saved on the memory(NOR-Flash), then display it on
the LCD.
<Adjustment Result>
You can see the adjustment result by using Log File saved on the memory card. You can also confirm the
ADJUSTMENT RESULT on the Tester mode.
5-5 Dust Reduction (ADJ_02)
■ It adjust the frequent voltage to remove the dust on the CMOS.
<How to adjust>
1. Change the setting on the tester mode as below.
- TEST MODE : Left → OK → Right → Ev + OK button at the same time.
- 3. Select ADJUSTMENT CONTROL
- (2) LINE PROCESS STEP value is 02.
- (3) LINE PROCESS MARK value is 01.
2. Insert the SD card to the camera which contained adjustment data.
3. After turning on the camera, it will be start automatically.
4. After completing the adjustment, camera turned off automatically.
<Adjustment Result>
You can see the adjustment result by using Log File saved on the memory card. You can also confirm the
ADJUSTMENT RESULT on the Tester mode.