44 English
Maint
aining y
our applianc
e
Maintaining your appliance
Before a self-cleaning cycle
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Don’t hand
Don’t hand
clean the
clean the
oven door
oven door
gasket.
gasket.
You may
You may
hand clean
hand clean
the door.
the door.
•
We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the self-
cleaning cycle.
•
Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.
•
Wipe up debris from the oven bottom.
(Fig. 1)
•
The silver-colored oven racks can be
self-cleaned, but they will darken, lose
their luster, and become hard to slide.
•
Residue on the front frame of the range
and outside the gasket on the door
will need to be cleaned by hand. Clean
these areas with hot water, soap-filled
steel-wool pads, or cleansers, such as
Soft Scrub. Rinse well with clean water
and dry.
•
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you
notice it becoming worn or frayed, have
it replaced. (Fig. 2)
•
Make sure the oven light bulb cover is
in place and the oven light is off.
NOTE
Remove oven racks and accessories before starting the self-clean mode.
How to run a self-cleaning cycle
1.
Select the length of time for the self-cleaning operation, e.g., 3 hours.
Press
Self Clean
once for a 3 hour clean time, twice for a 5 hour clean time, or
3 times for a 2 hour clean time
The default setting is 3 hours.
2.
Press
START/SET
to start the self-cleaning cycle.
The motor-driven door lock will engage automatically.
NOTE
•
You will not be able to start a self-cleaning cycle if the Oven lock feature
is activated or if the oven’s temperature is too hot.
•
The oven door locks automatically. The display will show the cleaning
time remaining. It is not be possible to open the oven door until the
temperature drops to a safe and cool temperature.
•
The self-cleaning feature will not operate when the warming center is on.
3.
When the self-cleaning cycle is done, End will appear in the display and the
range will beep several times.
How to delay the start of self-cleaning
1.
Press
Self Clean
.
Select the desired self-clean time by pressing
Self Clean
.
2.
Press
Delay Start
.
3.
Enter the time you want the clean cycle to start.
4.
Press
START/SET
.
The display will show Delay, Self clean, and the Lock icon. The motor-driven
door lock will engage automatically.
5.
The Self-Cleaning cycle will turn on automatically at the set time.
NE63T851_AA_DG68-01210A-05_EN+MES+CFR.indb 44
NE63T851_AA_DG68-01210A-05_EN+MES+CFR.indb 44
2022-04-14 오후 1:00:35
2022-04-14 오후 1:00:35