CHECKING THE INSTALLATION SITE
Clearances and dimensions
To install the range, refer to the following figure.
CAUTION
CAUTION
This range has been designed to comply with the maximum allowable wood
cabinet temperatures of 194 °F. Make sure the wall covering, countertops and cabinets around the
range can withstand the heat (up to 194 °F) generated by the range. If not, discoloration, delamination
or melting may occur.
SLIDE-IN CUTOUT
FREESTANDING CUTOUT
A
B
A
36"~36-4/5"
31”
4-1/2"
23-1/5"
6-3/10"
24-7/10"
48"
28-3/5"
26-3/10"
29-4/5"
26-3/10"
Hatched Faces should be
flat and leveled.
35-7/8"
23-3/16"
1/2" min.
25"
6"
3"
24"
3"
1" min.
A
B
6”
25”
3”
24”
3”
A : Cabinet opening
min 30” (76.2 cm)
B : Acceptable electrical outlet area
If your cabinet have height over 36-4/5", this range cannot be installed without supporting unit
like hard block.
CAUTION
CAUTION
You must use the rear filler kit to install the range in a freestanding cutout
cabinet. For more information, see “Optional rear filler kit” as shown below.
Optional rear filler kit
Used to fill gap between the range back and wall. Adds a filler strip to the rear of the range. This kit
can only be used when the opening in the countertop is 25" deep.
If the countertop depth is greater than 25", there will be a gap between the filler kit and the
back wall.
English - 20