E-
4
Getting Started
You have just purchased a wired remote controller and it has been installed
by your installation specialist.
Your User’s Manual contain much valuable information on using
your wired remote controller. Please take the time to read them as they will
help you take full advantage of the unit’s features.
In the manual, you will find a series of step-by-step procedures for each
function available.
The illustrations in the step-by-step procedures use 3 different symbols:
PRESS
PUSH
HOLD DOWN
Wired remote controller
The wired remote controller is installed on the wall.
Note
DIP switch setting is recognized during the initialization. If any changes are
mode to the DIP switch setting after the initialization, you have to initialize
the system by pressing
and
or reset the power.
Press the
button after cleaning the air filter.
sign will be off.
The remote controller will display the filter sign to alert the user to clean the
filter and turn off the display when the
button are pressed.
will be displayed if you press the button of the function that the
indoor unit does not support.
ON/OFF timer/
Error Status display
Operation mode
display
Fan speed/
Air swing display
Special function
display
ON/OFF time setup
Swing button(Except duct type)
Room temperature
check button
Filter Reset button(Except duct type)
Temperature
display
Operation ON/OFF button
Temperature setting
button
Fan speed setting
button
Mode selection
(”Quiet“ ”Sleep“
:
Except duct type)
MWR-WH00_IB_E_31218-1.indd 4
2009-12-14 ｿﾀﾈﾄ 12:52:26
