4. Disassembly and Reassembly
4-1 Replacement of Magnetron, Motor Assembly and Lamp
4-1 -1 Installation Instructions
Samsung Electronics
4-1
Remove the magnetron including the shield case, permanent
magnet, choke coils and capacitors (all of which are
contained in one assembly).
1. Disconnect all lead wires from the magnetron and lamp.
2. Remove the air cover.
3. Remove screws securing the magnetron to the wave guide.
4. Take out the magnetron very carefully.
5. Remove screws from the back panel.
6. Take out the fan motor.
7. Remove the oven lamp by pulling out from hole of air cover.
NOTE1: When removing the magnetron, make sure that
its antenna does not hit any adjacent parts, or it
may be damaged.
NOTE2: When replacing the magnetron, be sure to
remount the magnetron gasket in the correct
position and make sure the gasket is in good
condition.
CAUTION
• THIS OVEN WAS MANUFACTURED FOR USE IN A RECREATIONAL VEHICLE ONLY.
• THIS OVEN REQUIRES INSTALLATION INTO A CABINET STRUCTURE ONLY.
• THIS OVEN IS NOT DESIGNED FOR USE IN NON-CABINET INSTALLATIONS OR
FREESTANDING APPLICATIONS ADJACENT TO (WITHIN 2 FEET OF) ANY GAS OR ELECTRIC RANGE,COOKTOP, OR OVEN.
• PLUG THE THREE-PRONG POWER CORD INTO A PROPERLY GROUNDED OUTLET, 120V, 60Hz
OVEN INSTALLATION
• ALIGN THE SCREW HOLES ON UPPER AND LOWER TRIMS TO THE HOLES ON THE TOP ENCLOSURE AND
BOTTOM ENCLOSURE AND SECURE SCREWS. (Fig. 1)
• PLUG POWER CORD INTO RECEPTACLE, AND SLIDE OVEN INTO CABINET.
• SECURE OVEN TO CABINET THROUGH HOLES IN UPPER AND LOWER TRIMS. (Fig. 2)
• OVEN FEET MUST SIT ON CABINET FLOOR OR SUPPORT RUNNERS THAT ARE FLUSH WITH BOTTOM EDGE OF CABINET OPENING. (Fig. 2)
Lamp
Cover Air
Magnetron
H. V. Trans
H. V. Capacitor
Screw
SCREW
(Trim to outcase)
SCREW
(Trim to outcase)
SCREW
(Trim to cabinet)
(Fig. 1)
(Fig. 2)
Fan Motor
