GB
7
Connecting the AM(MW)/LW Aerial
The AM(MW)/LW aerial (for long and middle waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the
system and are marked AM ANT.
To avoid noise interference, check that the
loudspeaker wires do not run close to the aerial
wires. Always keep them at least 2 inches (5 cm)
away.
Connecting the FM Aerial
There are two types of aerials, follow the instructions below
(depending on option chosen).
How to connect a SCREW TYPE wire aerial.
The FM aerial connector terminals are located on the rear of the
system and marked FM(75
Ω
).
Spread the T.form FM aerial out and attach the ends to a wall,
in the position providing the best reception.
How to connect a COAXIAL TYPE areial (optional).
Connect a 75
Ω
antenna to the FM aerial terminal.
Plug the connector on the FM aerial supplied into the coaxial
socket (75
Ω
) marked FM on the rear of the system.
Follow the instructions given on Page 8 to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the
rear of the system, using a 75
Ω
coaxial cable (not supplied).
FM
FM
FM AERIAL
(supplied)
75
Ω
COAXIAL CABLE
(not supplied)
On/Standby
Volume
CD Repeat
A B
Band
Tuning Mode
Up
Down
Timer
Clock
Mute
EQ
S.Bass
TUNER
TAPE
AUX
CD
Содержание MM-L2
Страница 1: ...MICRO COMPONENT SYSTEM CD R RW PLAYBACK MM L2 Instruction Manual ...
Страница 17: ...MEMO ...
Страница 18: ...ELECTRONICS THIS APPLIANCE IS MANUFACTURED BY AH68 00954B ...