To take full advantage of your new micro-compact system, follow these
installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the sides
and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of the
system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed at
an equal distance above the floor.
Where to Install Your Micro-Compact
System
Connecting your System to the
Power Supply
ENG
8
Insert or replace remote control batteries when you:
Purchase the micro-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never
mix alkaline and manganese batteries.
Place your thumb on the position marked on the battery
compartment cover (rear of the remote control) and pull the cover in
the direction of the arrow.
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery a in the battery compartment
– on the battery against – in the battery compartment
Replace the cover by sliding it back until it clicks into position.
If you will not be using the remote control for a long time, remove the
batteries to prevent corrosion.
The remote control can be used up to approximately 7 meters(23 feet)
in a straight line. It can also be operated at a horizontal angle of up
to 30° from the remote control sensor.
Inserting Remote Control Batteries
1
2
3
Before plugging your system into a main socket, you must check the
voltage.
Plug the main lead into an appropriate socket.
Press the
(
POWER)
button to switch your micro-compact system
.
1
2
The loudspeaker connector terminals are located on the rear of the
system.
There are two terminals on the system:
left speaker (marked L)
right speaker (marked R)
To achieve the correct sound quality,insert those speaker connector
cables to the speaker connector terminals of the system.
Connecting the Loudspeakers
AUX IN
L
R
8
AUX IN
L
FM ANT
R
iPod
8
MM-D430-XAC-ENG-MIC.indd 8
MM-D430-XAC-ENG-MIC.indd 8
2011-3-28 11:09:34
2011-3-28 11:09:34
Содержание MM-D430
Страница 27: ...ENG 27 ...
Страница 29: ...AH68 02344Y REV 0 0 ...