15
ENGLISH
CLEANING YOUR MICROWAVE OVEN
The following parts of your microwave oven should be cleaned regularly to
prevent grease and food particles from building up:
• Inside and outside surfaces
• Door and door seals
• Turntable and roller rings
Always ensure that the door seals are clean and the door closes
properly.
Failure to maintain the oven in a clean condition could lead to
deterioration of the surface that could adversely affect the of the
appliance and possibly result in a hazardous situation.
1.
Clean the outside surfaces with a soft cloth and warm, soapy water.
Rinse and dry.
2.
Remove any splashes or stains on the inside surfaces or on the roller
ring with a soapy cloth. Rinse and dry.
3.
To loosen hardened food particles and remove smells, place a cup
of diluted lemon juice on the turntable and heat for ten minutes at
maximum power.
4.
Wash the dishwasher-safe plate whenever necessary.
Do not
spill water in the vents.
Never
use any abrasive products or
chemical solvents. Take particular care when cleaning the door seals to
ensure that no particles:
• Accumulate
• Prevent the door from closing correctly
STORING AND REPAIRING YOUR MICROWAVE OVEN
A few simple precautions should be taken when storing or having your
microwave oven serviced.
The oven must not be used if the door or door seals are damaged:
• Broken hinge
• Deteriorated seals
• Distorted or bent oven casing
Only a qualified microwave service technician should perform repair.
Never
remove the outer casing from the oven. If the oven is faulty and
needs servicing or you are in doubt about its condition:
• Unplug it from the wall socket
• Contact the nearest after-sales service centre
If you wish to store your oven away temporarily, choose a dry, dust-free
place.
Reason :
Dust and damp may adversely affect the working parts in the
oven.
This microwave oven is not intended for commercial use.
INSTALLATION & WIRING INSTRUCTIONS
IMPORTANT NOTE :
The mains lead on this equipment is supplied with a moulded plug
incorporating a fuse.
The value of the fuse is indicated on the pin face of the plug and, if it
requires replacing, a fuse approved to BS1363 of the same rating must be
used.
Never use the plug with the fuse cover omitted if the cover is detachable. If
a replacement fuse cover is required, it must be of the same colour as the
pin face of the plug.
Replacement covers are available from your Dealer. If the fitted plug is not
suitable for the power points in your house or the cable is not long enough
to reach a power point, you should obtain a suitable safety approved
extension lead or consult your Dealer for assistance. However, if there is no
alternative to cutting off the plug, remove the fuse and then safely dispose
of the plug. Do not connect the plug to a mains socket, as there is a risk of
shock hazard from the bared flexible cord.
ME76V-BBH_XEU-DE68-03927C.indd 15
2012-01-09 �� 2:04:50
