26
27
Satellite System
Screen Menu
>
Broadcasting
>
Channel Settings
>
Satellite System
Try Now
A set of satellite dish settings must be configured for each wanted satellite before performing a
channel scan.
Satellite System
is available when
Aerial
is set to
Satellite
.
"
The PIN input screen appears. Enter your 4 digit PIN number.
●
Satellite Selection
: You can choose the satellites for this TV.
Try Now
●
LNB Power
: Enables or disables the power supply for the LNB.
Try Now
●
LNB Settings
: Configures the outdoor equipment.
Try Now
Satellite
: Selects the satellite for receiving digital broadcasts.
Transponder
: Selects a transponder from the list or adds a new transponder.
DiSEqC Mode
: Selects DiSEqC mode for the selected LNB.
Lower LNB Oscillators
: Sets the LNB oscillators to a lower frequency.
Upper LNB Oscillators
: Sets the LNB oscillators to a higher frequency.
Tone 22 kHz
: Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should
be
Auto
.
●
SatCR/Unicable Settings
: Configure single cable installation.
Try Now
"
SatCR is short for satellite channel router.
"
This function may not support depending on the country.
SatCR/Unicable
: Enables or disable single cable installation support.
Slot Number (Tuner 1)
,
Slot Number (Tuner 2)
: Select the SatCR user slot number for this
receiver.
Slot Frequency (Tuner 1)
,
Slot Frequency (Tuner 2)
: Enter the appropriate frequency to receive
the signal from SatCR.
Detect Slot Frequency
: Auto-detect the signal frequency for the selected slot number.
Verify Slot Frequency
: Verify that the frequency entered corresponds to the selected slot.