Samsung Lazett Combo SCX-4216F, Руководство по обслуживанию

Страница: 75 / 135

6-13
Samsung Electronics
ALIGNMENT & ADJUSTMENTS
Service Manual
6.5.3 Data Setup
SEND LEVEL
You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
Caution: The Send Fax Level is set at the best condition in the shipment from factory. Never change settings
arbitrarily.
MODEM SPEED
You can set the maximum modem speed.
Communication is done with modem speed automatically set at lower speed when communicating with a slow-
er speed modem since communication is done on the standard of the side where modem speed is low for
transmission/reception. It is best set 33.6Kbps as default setting.
ERROR RATE
When the error rate is about to be over the setting value, the Baud rate automatically lowers up to 2400 bps to
make the error rate remain below the setting value.
You can select the rate between 5% and 10%.
CLEAR ALL MEMORY
The function resets the system to factory default settings.
This function is used to reset the system to the initial value when the product is functioning abnormally . All
the values are returned to the default values, and all the information, which was set by the user, will be
erased.
< Method >
1. Select the [MEMORY CLEAR] at the TECH MODE.
2. Push the ENTER button.
3. Select you country.
4. Push the ENTER button then it will clear all memory.
NOTICE : Always perform the memory clear after replacing the main board. Otherwise, the system
may not operate properly.
FLASH UPGRADE
The Firmware Upgrade function and has two methods, Local and Remote.
More information can be found in the firmware upgrade items.