INS
TALLA
TION
INSTALLATION
Installing a Clean Station
Approximately
0.5 m
Approximately
0.5 m
Status Indicator
Approximately
1 m
1
Connect the provided power cord to the
bottom of the Clean Station.
2
Position the power cord into the fixing
groove at the rear of the Clean Station.
3
Place the Clean Station on an even floor
and near an electrical outlet and plug it in.
❇
❇
When the Clean Station is plugged in, the
Status Indicator at the top of the Clean
Station turns white for a short time.
NOTE
• Install the Clean Station in a place where the floor and wall are level.
• If the power cord is too long for the installation environment, coil the power cord around the
cable management post, then put it in the fixing groove at the rear of the Clean Station.
• If you reinstall the Clean Station to a new position of 45 degrees or 1 m or more from the
previous installed place, recreate the map using the SmartThings App. (If you use the existing
map, some places may not be cleaned.)
English 13
VR9500_EN_00846J-02_SA.indd 13
2022-10-12 오후 10:46:08
