ENG - 8
3.
Press and hold the
VOL
button on the remote control for at least 5 seconds.
•
The
ID SET
message appears on the display of the Soundbar for a moment, and then it
disappears.
Sur
rou
nd
SOU
ND
MO
DE
Blue
toot
h
POW
ER
VOL
WOOFE
R
SOUNDB
AR
5 Sec
ID SET
4.
While the subwoofer’s indicator is blinking blue, press the
(Power)
button on your remote
control or on the right side of the main unit to turn on the main unit.
5.
The connection is complete if the indicator on the rear of the subwoofer stops blinking and glows
continuously.
• If the connection process fails, the blue indicator will flash continuously. Go back to Step 1 and
start again.
NOTES
•
Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
•
Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
•
If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the
STANDBY Blue LED on the rear will be off.
•
If you use a device that uses the same frequency (5.8GHz) as the Soundbar near the Soundbar,
interference may cause some sound interruption.
•
The maximum transmission distance of the wireless signal of the main unit is about 32.8 ft, but may
vary depending on your operating environment. If a steel-concrete or metallic wall is between the
main unit and the wireless subwoofer the system may not operate at all, because the wireless
signal cannot penetrate metal.
PRECAUTIONS
•
Wireless receiving antennas are built into the wireless subwoofer. Keep the units away from water
and moisture.
•
For optimal listening performance, make sure that the area around the wireless subwoofer and
Wireless Receiver Module (Sold separately) location is clear of any obstructions.
