Samsung HT-TKX500, Инструкция по эксплуатации

Страница: 21 / 84

0 1 0 1
Connecting the Wireless Receiving Amplifier (Con’t)
Resetting the Wireless Receiving Module
Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not
light up and the "REAR CHECK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.
1
With the main unit turned off, press and hold the remote
control's RESERVE button for 5 seconds.
The STANDBY LED on the front panel of the wireless
receiver module blinks.
With the wireless receiver module turned on, use a ball point
pen or a toothpick to press the RESET button on the back of
the unit.
The STANDBY LED on the front panel of the wireless receiver
module blinks 2 Times.
Press and hold the Power button on the home theater
system for more than 1 second to turn it on.
The LINK LED of the wireless receiver module is lit and the
Reset is complete.
If Power Standby mode continues, repeat Steps 1 to 3 above.
`
`
`
`
When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker Output
Connector on the back of the main unit.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and
moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is clear
of any obstructions.
Sound will be heard from the wireless rear speakers in DVD .1-CH or Dolby Pro Logic II mode only.
In 2-CH mode, no sound will be heard from the wireless rear speakers.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too
close to the main unit, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device
that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to
interference.
The transmission distance of radio wave is about 10m, but may vary depending on your operating environment.
If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system
may not operate at all, because the radio wave cannot penetrate metal.
•
•
•
•
•
•
•
•
HT-TKX500_CIS_ENG-0205.indd 20 2008-02-16 �� 1:34:25