Wireless Microphone
2
1
•
To adjust the channel of microphone, open
the channel cover using tweezers.
•
To adjust the channel of main unit.
•
If you do not use microphone, turn off the
power switch. LED will turn off and the
microphone cannot be used.
Connect a wireless micro
phone antenna to the
antenna connector of the
rear panel.
Insert alkaline batteries
(1.5VX3) in the power part
of microphone.
3
Approve the power to the
microphone and set same
channel for microphone and
main unit before use (refer
to channel setup table).
4
When you turn on the
power switch of microphone
after setting the channel,
LED will light and the
microphone is ready to use.
59
60
Dip Switch NO.
Channel NO.
1
2
3
4
ON
OFF
OFF
OFF
Ch1
OFF
ON
OFF
OFF
Ch2
ON
ON
OFF
OFF
Ch3
OFF
OFF
ON
OFF
Ch4
ON
OFF
ON
OFF
Ch5
OFF
ON
ON
OFF
Ch6
ON
ON
ON
OFF
Ch7
OFF
OFF
OFF
ON
Ch8
ON
OFF
OFF
ON
Ch9
OFF
ON
OFF
ON
Ch10
Channel Setup Table
Note
• Make sure to set the same channel for main unit.
Main unit and microphone should have same channels to enable transmission and
reception between them.
• Use alkaline battery for power as much as possible.
Ordinary battery may cause shorter service life of microphone and main unit and may
deteriorate the performance.
• Make sure to turn off the power switch before inserting the batteries, and check the
polarity (+)(-) of battery when inserting the battery.
• If you drop the battery in the water accidentally during use, immediately turn off the
power switch and contact the A/S center.
• RF noise may occur in the area near railroad, power line and big motor where high
voltage runs and EMI noise occurs.
• Since the internal parts of device are manufactured precisely, do not disassemble it as
you want.
• Make sure to remove and keep the batteries in safe place, if you do not use it for long
period of time.
SETUP