16
English
English
17
02
Connections
Installing the Speakers on the Tallboy Stand
* HT-E453 only - Front Speakers
* HT-E455 only - Front/Surround Speakers
1.
Turn the Stand Base upside-down and connect it to the Stand.
2.
Insert three screws (5*15, For connecting Stand & Stand Base) clockwise
into the three holes marked using a screwdriver as shown in the illustration.
!
CAUTION :
When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged. (torque
screwdriver- below 15 kg.f.cm)
3.
Straighten a supplied speaker wire and put in the hole on the centre of
Stand Base.
4.
Connect the upper Speaker to the assembled Stand.
5.
Insert another large screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a screwdriver.
6.
This is the appearance after the speaker is installed. Follow this
steps to install other speaker.
Connecting The Speakers
1.
Press down the terminal tab on the back of the speaker. (HT-E453/E455
Only)
2.
Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.(HT-E453/E455 Only)
3.
Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
Black
Red
In case of HT-E450
Front Speaker (R)
Subwoofer
Surround Speaker (R)
Surround Speaker (L)
Front Speaker (L)
Center Speaker
* Refer to page 16 for the speakers of HT-E453/E455.
FM ANT
DIGITAL
AUDIO IN
OPTICAL
SURROUND
SUBWOOFER SURROUND
SPEAKERS OUT
HDMI OUT
AUX IN 2
VIDEO
OUT
FA NET
(Only For Service)
5
3
2
6
1
4
Stand Base
Stand
Speaker
Stand