14
Connecting the Video to TV
CONNECTIONS
13
VOLTAGE
SELECTOR
Composite
Video
Component
Video
S-Video
TV
•
When the Progressive scan mode is selected, the VIDEO and S-VIDEO
outputs do not feed any signals.
Note
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
S-Video (Better Quality)
If you television is equipped with an S-Video input, connect an S-Video cable (not supplied)
from the S-VIDEO OUT jack on the back panel of the system to the S-VIDEO IN jack on
your television.
Component Video (Best Quality)
If your television is equipped with Component Video inputs, connect a component video
cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the
corresponding jacks on your television.
*
Depending on your TV, Component Video input connectors may be marked as DVD Video input connectors.
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
•
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
Cooling Fan
Connecting the Antennas
Connect the FM antenna supplied to the
FM 75
Ω
COAXIAL terminal as a
temporary measure.
Slowly move the antenna wire around
until you find a location where reception
is good, then fasten it to a wall or other
rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75
Ω
coaxial cable (with a standard type connector),
disconnect the supplied FM antenna.
FM antenna connection
VOLTAGE
SELECTOR
1
2
3
1
2
Connect the AM loop antenna supplied
to the AM and terminals.
If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
AM(MW) antenna connection
1
2
VOLTAGE
SELECTOR
FM Antenna (supplied)
Snap the tabs on the
loop into the slots of the
base to assemble the
AM loop antenna.
AM Loop Antenna
(supplied)
If AM reception is poor, connect an outdoor
AM antenna(not supplied).