Samsung HP-P4271, Инструкция пользователя

Страница: 13 / 116

13
Notes
• Contact an authorized technician when installing the wall attachment panel.
• After hanging the PDP panel on the wall attachment panel, make sure that the Insulation
holders are completely hung.
• Be careful not to get your fingers caught during installation.
• Make sure the wall attachment panel brackets are tightened. Otherwise, the PDP panel may
fall down.
• Please secure the mounting bracket on the wall surface after setting its angle at 0°.
How to Adjust Mounting Angle
Note:
Please secure the mounting bracket on the wall surface after setting its angle at 0°.
Factory default How to Adjust Mounting Angle
Please tighten the captive screw in the direction
of the arrow after assembling the bracket. Hold onto the middle of the PDP to adjust
the angle (not the sides of the PDP).
1 Secure the SET to the wall mount bracket.
(Please refer to the following instructions.)
2 Set the angle by pulling the upper end of the SET attached
to bracket in the direction of the arrow.
3
The angle can be adjusted from 0° to 15° by ±2°.
Change Angle
1 Be sure to remove the safety pins underneath the PDP.
(
Caution
: If the safety pins are not removed, the angle cannot
be adjusted.) Any attempt to do so may cause damage to the PDP.
2
Hold onto the bottom of the PDP and pull forward fully as
directed by the arrow(as illustrated) to adjust the angle.
(0°~20° by 2°). Insert the Safety Pins to the front guide
holes on both sides as illustrated in figure
´
.
3 Viewing the PDP after connecting the external devices.
Remove the Safety Pins to adjust the angle to 0°, then
secure the Safety Pins again. (
Warning
: For safety, be sure to
secure the PDP using the safety pins. If the safety pins are not
used, the PDP may fall, causing serious injury.)
Connecting External Devices to the PDP
BN68-00757A-X1Eng_002~027 7/26/04 1:37 PM Page 13