•
RJP (Remote Jack Pack)
: The RJP is a hardware module that has various audio and video inputs (PC and HDMI) and
corresponding outputs. The corresponding outputs are connected from the RJP to the TV. The RJP communicates
with the TV via RS232. The RJP communicates with the TV by sending messages regarding active or inactive
sources.
– A group of
Hotel Option
menu items let you assign numbered priorities to the jacks of the RJP.
1
is the highest
priority and
2
is the lowest. When a guest connects external sources to the RJP jacks, the TV will automatically
switch between sources based on the priority you have assigned them in the
Hotel Option
menu. For example,
lets say
HDMI 1
is set to
1
and
HDMI 2
to
2
. If a guest has attached a device to the
HDMI 2
jack, and then plugs a
device into the
HDMI 1
jack, the TV automatically switches to the device plugged into the
HDMI 1
jack (the jack
with the higher priority). Note that a guest can also switch between devices manually by pushing a button on
the RJP.
•
To reset the RJP to its factory default state, press the
HDMI 1
and
HDMI 2
buttons simultaneously for 10 seconds.
When all button LEDs blink 5 times, the RJP reset is complete.
• The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room.
The LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer
will restart. If the guest then touches another source button, the TV will change to the selected source and the
corresponding LED will be lit.
•
After the RJP reset or the TV turns off/on, it takes approximately 10 seconds to establish communications between
the TV and the RJP.
•
The following table shows the approximate time in seconds it takes to switch from the TV to an input source, based
on assigned or default priorities.
– When no inputs are connected.
Source
To Connect
HDMI
3.9
sec
– When two or more inputs are connected to the RJP and one of the input sources is disconnected and then
reconnected.
Source
Disconnect
To Connect
Total
HDMI
3.9
sec
3.9
sec
7.8 sec
–
If the RJP has all its live sources connected, HDMI has been assigned the highest priority, the RJP is in HDMI
mode, and a guest removes and reconnects the HDMI source, the minimum time required to switch to the
HDMI 1
source is 7.8 seconds.
–
HDMI Music Mode
is available for the Guestlink RJP only.
English - 23
