English - 11
Lack of salt indicator (*applicable models only)
-
Turns on when the water softener runs out of salt. (or the dishwasher is
in the standby or pause modes.)
-
Turns off while the dishwasher is operating.
10
Delay Start
Delay a cycle for up to 24 hours in one-hour increments. To increase the delay
start time, press or hold the
Delay Start
button. The hour displayed indicates
the time at which the wash will be started.
-
After setting the delay time, press the
Start
button, and then close the
door to start the cycle.
-
If you want to change the delay time once the dishwasher has started,
press the
Reset
button and turn off the dishwasher. Then, turn on the
dishwasher again and select a new cycle with a new delay setting.
11
Start
To start a cycle, press the
Start
button before closing the door.
*
Reset
: To cancel a currently running cycle and drain the dishwasher, press
and hold the
Start
button for three (3) seconds.
Once the dishwasher is reset, select a cycle and option, and then press
Start
to restart the dishwasher.
You can select options (Self Clean, Upper, Lower, Speed Booster, Sanitize, Dry+, Delay Start) before
starting a cycle. If you change the cycle after selecting an option, the original cycle is reset.
To prevent the touchpad from losing response sensitivity, follow these instructions:
-
Touch the center of each keypad using one fi nger. Do not push.
-
Clean the touch control’s surface regularly with a soft, damp cloth.
-
Be careful not to touch more than one touch key pad at a time, except as directed.
When you pause a cycle by opening the door during operation, press the
Start
button before closing
the door to continue the cycle.
O O X
03 using your dishwasher
DW80H994_DD68-00164A-01_EN.indd 11
DW80H994_DD68-00164A-01_EN.indd 11
2015-01-06 4:16:04
2015-01-06 4:16:04
