Samsung DW60M9990AP, Руководство по установке

Страница: 25 / 84

Installation
English 25
STEP 8 Final check
1. Remove all foam, paper packaging, and unnecessary parts from inside the dishwasher.
2. Turn the circuit breaker on.
3.
Open the water valve to supply water to the dishwasher.
4.
Plug in the dishwasher.
5. Turn the dishwasher on, and then select and run a cycle.
6. Check if the dishwasher turns on normally and if there are any water leaks while the
dishwasher is operating. Make sure to check for water leaks on both ends of the water
line and the drain hose connector.
7. Check if the kick plate gasket is attached to the bottom of the kick plate. To install the
kick plate, see the Kick plate section below.
To fix leaks
You may encounter leaks during the final check. If this is the case, follow these
instructions.
1.
If an information code of LC appears
on the control panel, press and hold
START for more than 3 seconds to
start draining. When the draining is
complete, unplug the dishwasher and
close the water valve.
2. Check if the inlet valve leaks. If so,
reconnect the 90°Fitting with the hot
water line because they were not
properly connected.
DW9900M_DD68-00197B-01_EN.indd 25 2017-09-04 4:42:20