Samsung DW60M5060BB, Руководство пользователя

Страница: 163 / 180

Installation Instruction _ 16 3
07 INS
TALLA
TION INS
TRUC
TION
Advice regarding the first wash cycle
After the appliance has been installed, immediately before running the first wash cycle,
completely fill the salt dispenser with and add approximately 1.2 Kg of salt (see Rinse aid and
refined salt). The water may overflow: this is normal and is not a cause for concern. It is also
normal that the LOW SALT indicator light continues to flash for a few cycles after the salt has
been loaded.
Positioning the appliance
Position the appliance in the desired location. The back should rest against the wall behind it,
and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply
and drain hoses that can be positioned to the right or the left to facilitate proper installation.
Leveling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the height of
the dishwasher, making it level. In any case, the appliance should not be inclined more than 2.
The maximum adjustment height of the feet is 7 0 mm.
How to drain excess water from hoses
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or a suitable
container that is held outside and lower than the sink.
Water outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension hose
If you need a drain hose extension, observe to use a similar drain hose.
reduced.
Syphon connection
The waste connection must be at a height of between 50cm (minimum) and 100cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip.
DW4000KM-00000A-00_EN (Basic)_160323.indd
163