English - 22
Before using the product for
the fi rst time
SETTING MODE
Turn on the dishwasher, and hold down both the
Sanitize
and
Delay Start
buttons for 3 seconds to enter
Settings mode.
Pressing the
Sanitize
button changes the mode in this sequence:
Sound settings mode
Brightness mode (for some models)
Water refl ector mode
Water softener mode (for some models)
Auto Door mode (for some models).
Sound settings mode
Press the
Sanitize
button until “
U1
” or “
U0
” is displayed. To change the setting, press the
Delay Start
button. “
U0
” means that the sound is off for all cycles.
This setting is continue before changing again.
Water softener mode (Water hardness level setting)
1.
Press the
Sanitize
button to enter Water softener mode (“L3” on the display indicates Water softener
mode).
2.
Once you enter the setting for the water hardness, the current hardness level setting is displayed.
3.
Use the
Delay Start
button to select the water hardness level from Level 0 to Level 5.
(Refer to the table below for the water hardness level setting in your area.)
If the water hardness level in your area is very low, you do not need to use dishwasher salt.
However, you need to set the water hardness setting for the dishwasher to 0.
4.
To exit the water hardness setting, press the
Power
button.
Water hardness level chart
The water hardness is measured using German degrees (°dH), French degrees (°TH), or mmol/ℓ
(International unit for the water hardness).
Level
Water hardness
Regeneration softening/
washing cycle (ECO program)
Salt
injection
ºdH
ºTH
mmol/ℓ
Range
0
<6
<10
<1.0
No
recycle
No
No
1
6-14
10-25
1-2.5
1/8
Yes
Yes
2
14-23
25-40
2.5-4.0
1/5
Yes
Yes
3
23-31
40-55
4.0-5.5
1/3
Yes
Yes
4
31-40
55-70
5.5-7.0
1/2
Yes
Yes
5
>40
>70
>7.0
1/1
Yes
Yes
FS_DW9000H-00158A-08_EN.indd 22
FS_DW9000H-00158A-08_EN.indd 22
2016-08-12 5:20:33
2016-08-12 5:20:33