English - 13
02 SETTING UP
8
Dry+
(Control Lock)
Use this option when you want to dry your dishes more completely.
The
Dry+
option features a longer drying phase and higher temperatures in the
last rinse cycle, resulting in improved drying performance with slightly higher
power consumption.
*
Control Lock
: This option allows you to lock the buttons on the control
panel - except the
Power
button - so children cannot accidently start the
dishwasher by pressing the buttons on the panel. Only the
Power
button
remains active.
To
lock
or
unlock
the buttons on the control panel, press and hold the
Dry+
(Control Lock)
button for three (3) seconds.
• When the Power is On : Press and hold the “
Dry+ (Control Lock)
” button
for three (3) seconds.
• When the Power is Off : Push the
Power
button fi rst, and then press and
hold the “
Dry+ (Control Lock)
” button for three (3) seconds.
• Control Lock remains active until you turn it off . You cannot select cycles or
options or start the dishwasher when Control Lock is on.
9
Display
Displays cycle time and remaining hours and minutes, Delay Start hours, and
check messages.
If an problem occurs during an operation, an check message is displayed with
a warning sound.
Refer to the
“Information codes”
section on page
33
.
Control Lock
indicator
-
Turns on if the Control Lock is set (or the dishwasher is in the standby or
pause modes).
- Turns
off while the dishwasher is operating.
-
When Control Lock is on, the Control Lock indicator blinks for several
seconds if any button except the Power button is pressed.
Self Clean
indicator
-
Turns on when the Self Clean option is enabled (or the dishwasher is
in the standby or pause modes), but turns off while the dishwasher is
operating.
-
Blinks for 5 seconds every 20 to 22 cycles.
-
The cycle counter disappears when the Self Clean operation is complete
or when the dishwasher reaches the 23rd cycle without the Self Clean
cycle being used. (The Reset or Self Clean operation is not counted by
the cycle counter.)
Rinse Refi ll
indicator
-
Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in
the standby or pause modes).
- Turns
off while the dishwasher is operating.
Lack of salt
indicator (*applicable models only)
-
Turns on when the water softener runs out of salt. (or the dishwasher is
in the standby or pause modes.)
- Turns
off while the dishwasher is operating.
BU_DW9000H-00156A-07_EN.indd 13
BU_DW9000H-00156A-07_EN.indd 13
2016-09-20 12:31:38
2016-09-20 12:31:38
