troubleshooting
_27
pROblem
pOSSIble CAUSe
SOlUTION
Leaves an oily film on the
dishes. The dishes are
not clean enough.
The amount of detergent is incorrect. Supply the appropriate amount of
automatic dishwasher detergent.
Too many dishes have been loaded.
Load only an appropriate number of
dishes.
Dishes are loaded incorrectly.
Load your dishes as recommended
(refer to the “Loading the top and
bottom baskets” section).
The pressure of the supplied water is
insufficient.
The proper pressure of the supplied
water is 0.05 ~ 0.8 MPa.
Improper detergent is being used.
Use an automatic dishwasher
detergent.
There is no rinse aid.
Check the dispenser and add rinse
aid.
The water is too hard.
Add salt into the salt container.
Is too noisy.
Sound is generated when the
dispenser cover is open. Sound is
generated when the drain pump is
operating at an early stage.
This is a normal operation.
The dishwasher is not level.
Ensure that the dishwasher is level.
There is a ‘chopping’ sound because
a nozzle is bumping against the
dishes.
Rearrange the dishes.
Leaves glasses with a
dim polish.
The supplied water is soft and too
much detergent is being supplied.
Underload the dishwasher and use a
rinse aid to minimize this.
Leaves black or gray
marks on the dishes.
Aluminum dishes have been loaded.
Remove the marks on the dishes
using a low sensitivity cleaner.
Leaves a yellow or brown
film on the inside of the
dishwasher.
This occurs from coffee and tea
soils.
Remove the soils using a spot
cleaner.
Does not have any lamps
lit.
The power is not connected.
Connect the power cord.
Does not have a
smoothly rotating spray
arm.
The nozzle hole is clogged with food
particles.
Clean the nozzle hole.
has a bent top basket
after loading dishes.
The dishes are not loaded properly.
Load your dishes as recommended
(refer to the “Loading the top and
bottom baskets” section).
05 tr
oubleshooting
UserManual-DMS400TU_GB.indd 27
2010-06-13 �� 9:33:48
