7
No Problem
What To Do
8
The igniter does not
glow
If the igniter does not heat up, remove power and using an
ohmmeter, check the following:
•
Open flame sensor
•
Open igniter
•
Shorted booster coil
•
Open wiring
•
Bad motor switch ( Neutral supply)
•
No power from control ( L1 supply)
9
Igniter glows - No gas
ignition
If the igniter heats up but the main burner flame is not ignited,
remove power and using an ohmmeter, check the following:
•
Open secondary coil
•
Open holding coil
•
Open wire harness
•
Stuck flame sensor (Stuck closed)
10
The gas is ignited but
the flame goes out
If a normal ignition takes place and after a short while the flame goes
out, check for the following:
•
Radiant sensor contacts opening prematurely.
•
Weak gas valve coil may open when stressed by higher Temps.
•
Weak Hi-Limit
•
Poor venting
•
Bad drum seals
11
Improper drying
clothes wrinkled
Rough texture long
dry time
•
Lint filter is not clean.
•
Restriction in exhaust.
•
Outside exhaust hood damper door stuck closed.
•
Exhaust too long, too many elbows, flex ductwork installed.
•
Poor intake air available for the dryer.
•
Incorrect tumbler speed. Tumbler belt slipping.
•
Blower impeller bound; check for foreign material in blower area.
•
Customer overloading dryer.
•
Check clothing labels for fabric content and cycle selected.
•
Clothes too wet due to insufficient spin out by washer.
12
Noisy and/Or
Vibration
•
Thumping Check for loose tumbler baffle, rear tumbler roller(s)
worn or misaligned, out-of-round tumbler or high weld seam on
tumbler.
•
Ticking Check for loose wire harness or object caught in blower
wheel area.
•
Scraping Check for front or rear bulkhead felt seal out of
position or worn tumbler front bearings.
•
Roaring Check for blower wheel rubbing on blower housing or
bad motor bearings.
•
Popping or squealing sound. Check for a sticky or frayed belt.
TROUBLE SHOOTING
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
(Technical)DV405-02365H-02_EN.indd 7
2012-06-19 �� 1:25:54
