GB-17
DTB-B570E
GB
OPERATING THE RECEIVER
GB-16
D I G I T A L T E R R E S T R I A L R E C E I V E R
DTB-B570E
OPERATING THE RECEIVER
1.1 Auto Scanning
The sub menu “
Auto Scanning
” will enable download of
the channels automatically from the preprogrammed load.
To download channels automatically:
●
You can select the specified frequency between Start
Frequency and End Frequency.
●
Press the
OK
key.
Auto Scanning menu will be displayed.
All the channels in the list will be automatically downloaded.
1.2 Manual Scanning
To tune-in new channels and weak signals, the STB has
been provided with the option “Manual Scanning” where
the channel data can be entered by the user.
After selecting the “
Manual Scanning
” from the Installation
Menu, the following screen will be displayed:
●
Select the Channel Number.
You can select the specified channel you want to find.
The followings are defined as a default, but optionally you can
choose it.
Signal Status bar shows you if it is valid.
●
Input the frequency of the channel you want to find.
●
Select the bandwidth.
You can select the value of 6, 7 or 8 MHz.
●
Select the Guard Interval Mode.
You can select the value of Auto, 1/32, 1/16, 1/8, or 1/4.
●
Select the FFT (Fast Fourier Transform) Mode.
The value of AUTO, 2K and 8K is settings automatically.
●
After select option, press the OK key to start the scanning
process.
1.3 Reset to Factory Defaults
This is to restore the factory set values in case the user has
encountered some problems after changing any values of
channel data and others which may be in error.
At the request window, if you press the
OK
key, the receiver
will be reset to factory default settings automatically.
N
No
otte
e
: This cause your previous settings to be deleted!
00427A_B570E_XET_Eng2304 4/23/07 8:23 PM Page 16