Setting up your French Door
Refrigerator
Installing the water filter
1. Remove the water filter cover(
1
)
2. Remove the fixed cap by turning it counter
clockwise. Keep the cap in a safe place for later
use if you don’t use a filter.
3. Remove the water filter from the box and put
a replacement indicator sticker on the filter as
shown. Place a sticker on the filter that dates
six months in the future. For example, if you
install the water filter in March, put the “SEP”
sticker on the filter to remind you to replace
in September. That way you’ll know when it is
time to replace the filter. Normally, a filter life is
about 6 months.
4. Remove the filter cap and insert the filter into
the filter housing.
5. Slowly turn the water filter 90º clockwise to
align with the printing mark on the cover,
locking the filter in position. Make sure to align
the water filter label mark with center of cover
filter printing as illustrated. Remember, do not
over-tighten.
2
3
1
4
5
Sticker
(month indicator)
Separation
of red cap.
Cover filter.
Turn until the
labels are
aligned.
You should remove the right side upper glass
shelf before installing water filters.
Removing any residual matter inside the water supply line after installing the
water filter.
1. Turn ON the main water supply.
2. Run water through the dispenser until the water runs clear 3L. This will
clean the water supply system and remove air from the lines.
3. Additional flushing may be required in some households. But , the filter will
have an operational life proportional to the quality of the water supplied).
The time is not guaranteed.
4. Open the Refrigerator door and make sure there are no water leaks coming
from the water filter.
Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser. This
means that there is still air in the line.
16_
Setting Up
DA99-01623D.indb 16
2010.5.7 9:34:11 AM
