30
WATER
ICE
2) When you press the test button, the ice cube container is
filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker
but of the water pressure in
the pipe, and occurs frequently.
When this problem occurs, contact
a service person to check the
amount of water supplied.
INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
Check the amount of water supplied to the ice tray.
1) Lift up (
①
) and pull out (
➁
) the ice maker bucket in the freezer.
ICE MAKER
1) Turn on the main water supply & shut-off the valve of the
water supply line.
2) Run water through the dispenser about the first six glassfuls
of water. This will clean the water supply system and clear
air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
• Before reinstalling the water filter, remove the wine shelf (Optional).
NOTE
CHECK THE WATER LEVEL
TEST BUTTON
TOO HIGH
OPTIMUM
LEVEL
TOO LOW
