10
6)Temperature Unit—Choose the
℃ or ℉ for
temperature
unit
7). Temperature Alert – Sets the temperature alert range.
Once the temperature on camera side is out of the range, the
monitor will beep to alert you.
8). A/V Out – Chooses the TV system for A/V output.
9).Factory Reset– Choose
Yes
to reset the receiver to factory
defaults. All menu settings will be reset.
NOTE: Resetting the receiver will not reset all camera pairing.
10)
Pairing– Use the pairing menu to add camera(s) to the receiver.
Auto mute
This function is to automatically cut off the audio when there is
only slight environmental noise on camera side. Choose Yes to
enable this function.
When auto mute function is enabled, the monitor audio will be
cut off after 5 minutes when there is only slight environmental
noise on camera side. seconds
In auto mute mode, the audio can be activated by real noise or
higher sound detected on camera side. After last activation, the
monitor audio will go back to off status when there is no sound
trigger within 5 minutes.
Time Alarm
You can set the time value with HH,MM and select the ON or
OFF to decide alarm or not.
Use LEFT and RIGHT arrows to select HH,MM ,then use
the UP and DOWN
▼▲
arrows to set the time value. After
successfully setting the time value , choose
ON
and then press
the
OK
button to confirm the setting.
Selected ON, it can awake on the preset time. While choose
OFF, the function will be shut down.
Screen Saver
5 pictures are stored in the system. You can select one picture
to make it be shown on the LCD screen in scan mode. Or you
